Veteran Garage Door Repair | Keller TX | 817-769-8488

Garage Door Opener Repair

You might discover that your garage door opener has actually been giving you issues, so you require to repair it. You can fix it by changing a circuit board, a photo-eye sensor, the major drive equipment, or the set-limit switches. You can also inspect if the safety and security sensing units are functioning properly.

Changing a circuit card

Replacing a motherboard for your garage door opener requires a few steps and devices. First, you require to shut off the circuit breaker as well as detach any type of cables. Next off, open up the circuit board cover. This will certainly help you to detect the trouble and establish if you need a brand-new board. Next, remove the old board as well as its wire ports.

You can after that continue to change the motherboard. The replacement process is easy as well as takes around 10 minutes. A brand-new circuit board will certainly set you back concerning $80. To shield your brand-new circuit board from power rises, you can purchase a rise protector.

Changing a photo-eye sensor

Replacing a photo-eye sensing unit can be a relatively simple task. First, eliminate the sensor from the door as well as see to it is positioned appropriately. If the sensor is angled whatsoever, it might not be obtaining the correct signal, which might be creating the strobe lights. If you observe that the photo-eyes run out alignment, you might need to have actually a technician come and also take care of the trouble.

The photo-eye sensor includes 2 pieces that install outside of the door tracks as well as toward the floor. The image eyes will have a small LED light as well as should be solid in color. If the light is blinking, its likely the photo-eye is faulty as well as will require to be replaced.

Changing a main drive gear

To replace a garage door opener primary drive equipment, start by getting rid of the cap from the chain pulley. Next, remove both screws holding the drive gear to the gear assembly. Now, you can unfasten the 3 tension pins. Press them from both sides and after that eliminate them. After that, disconnect the three cables from the garage door opener electric motor. These cables should be white, red, as well as blue.

When you have actually eliminated the old equipment, set up a brand-new one. Make sure to grease it well. Put the new gear into the shaft, seeing to it to align the placing openings. Ensure the gear as well as gear assembly are located properly to make sure smooth operation. Next off, make use of a hammer as well as a nail to drive a pin right into the brand-new equipment.

Adjusting the set-limit buttons

The first thing you ought to do if your garage door is not working appropriately is to inspect the set-limit switches. You may need to change them to ensure that the door closes earlier or stops prior to it reaches the flooring. You can check this by looking at your garage doors manual or online.

To readjust the set-limit switches, youll require a screwdriver or socket. Readjust the handle clockwise or counterclockwise till the door goes up and also quits, or decreases its range. To look for correct traveling range, measure the void from all-time low of the garage door to the ground.

Veteran Garage Door Repair – Keller

204 S Main St Ste 105, Keller, TX 76248, USA

817-769-8488

https://veterangaragedoor.com/veteran-garage-door-repair-of-keller-tx/


Garage Door Repair


Garage Door Installation


Garage Door Company


Garage Door Service


Garage Door Opener Repair

Veteran Garage Door Repair

204 S Main St Ste 105
Keller,TX
76248
817-769-8488

Leave a Reply

Your email address will not be published. Required fields are marked *

Back To Top